1, according to the same level received corner installed.
2, according to different requirements of different skeleton, such as: L50*50*5mm angle fixed, embedded aluminium pendant, and according to the different products have different methods.
3, pre-installed in Gusset Plate hanging on the keel, together with the Gusset Plate close to the light steel keel the keel vertical button below the light steel keel, ceiling joist spacing according to the Board to determine the size of all loading must be adjusted to the level.
4, the deduction in the keel plate order, each Finish button one, will be locked in under pressure, keel connections connections for the connection.
5, the Board must wear gloves when installing, in case of leaving fingerprints or stains, use detergent wash and wipe dry.
In the building wall decoration, aluminum panel in the decoration effect and the selection of installation structure, there are three commonly used installation methods, aluminum panel installation methods are: aluminum panel seam installation, aluminum panel dense installation, on the plug type dense installation.
1, pull the cable fixed position
Before installing the aluminum boards, pull the control cables according to the horizontal and height positions. Ensure that the vertical and vertical directions of the control cables are straightened to avoid tilt and asymmetry after the aluminum boards are installed. You need to prepare aluminum panel materials in advance and select the corresponding size according to the area size.
- Installation of keel
Next is the installation of the keel, the installation of the keel is the most important part of the installation of aluminum panel. The installation can directly affect the overall effect. If the installation is not firm, it will cause the aluminum panel to fall off. Then the keel welded in advance is fixed on the main wall, and the infrared ray is used to keep it neat. This process should be very careful, and no error must be allowed. There needs to be a certain appropriate spacing between the skeleton and the skeleton. After determining the position, it can be fixed with screws.
3, the surface of the keel rust treatment
After the keel is installed, it is still necessary to do a layer of anti-rust treatment on the surface of the keel. Even if the keel is made of hot-dip galvanized steel, it is not easy to rust under normal circumstances. Even if it is, the welding place must do a good job of anti-rust protection. In order to achieve better results, it is necessary to do a good job of anti-rust treatment before fixing, to prevent corrosion, but also on the surface coated with a layer of metal anti-rust paint, so as to prevent the skeleton keel from rusting when it meets water.
- Installation of aluminum panel
After the anti-rust treatment in front, the following began to install aluminum panel, prepare the aluminum panel to use in advance, confirm that each aluminum panel orderly pressed on the keel, the arrangement between aluminum panel needs to keep tight, with some force will be aluminum panel buckle on the keel, confirm that the surface is smooth. Then use screws to fix it, according to the sequence of the buckle, before the installation of another piece.
- Seal and glue
After all the aluminum panel is confirmed and installed, the next step is to do the surface sealing treatment, the purpose is to make the surface waterproof. You need to use weatherproof glue to fill the gaps in the aluminum panel, and then clean the excess glue, and finally clean the surface.
Summary: The performance of aluminum panel is very stable, relatively speaking, this material is relatively high cost performance, construction is very convenient, recycling value is large, conducive to environmental protection.
